3rd Hand Plaster with Fibers

Description

Cement base 3rd hand plaster reinforced with fibers for interior and exterior use.

It conforms to European Standard ΕΝ998-1 specifications.

 

Advantages

  • Ready for application
  • Stable standardized properties
  • High Adherence and Resistance

 

Range of Application

Finish plaster for interior and exterior use on 2nd hand plastered surfaces. 

Product Identity    

  • Appearance - Color: Grey cement-based powder    
  • Packaging: 25 kg bags    
  • Storage: 8 months in the original packaging and in a dry place    
  • Particle size: 0-800μm  

Application Data    

  • Mixing Ratio: 25kg in 8-9L water    
  • Pot life: 1 hour at 23 oC and 50% RH    
  • Thickness: 2-4mm/coat    
  • Consumption: 3-5 kg/m2 depending on surface    
  • Application temperature: +5 ºC - +35 ºC  

Final Performance    

  • Adhesion strength: 0.3 Ν/mm2– FP:B    
  • Compressive strength: CSIII    
  • Water absorption: W0    
  • Thermal conductivity (λ10,dry): 0.4 W/m∙K  
  • Apply by hand using a float or a trowel in two coats. The 2nd coat is applied only when the first one has been set.     
  • The final surface may either be finished with a trowel covered with sponge or made smooth with a steel trowel’s edge. The surface should be lightly dampened, for 2–3 days, beginning 24 hours after application, especially in hot weather, with intense evaporation.  

Preparation of substrates    

  • The substrate must be solid, free of dust, loose parts and oils.    
  • The substrate has to be flat without any anomalies for better final appliance.      
  • To avoid immediate absorption of mix water by the substrate and for better adhesion saturate the surface to provide a saturated surface dry condition.  

Preparing the mix    

  • Pour the material into a clean water and mix (mix in a concrete machine for big quantities or with a low speed electric mixer for small quantities) until a homogeneous mix is obtained.   
  • Allow mixture settle for 5 minutes prior the application. Attention! Additional water will make your mixture sloppy and may cause negative results on final strength.      
  • Use the mixture when is still fresh. Do not leave the mix unmixed for a long time.    
  • Do not mix with water or latex additive when the mixture starts to set in the bucket. In such case the mix should be dropped.  

To Find a Shop for this product, click here.