SMART PLAST Thick

Description

Cement based, super strength,initial-final plaster for interior and exterior use.

It conforms to European Standard ΕΝ998-1 specifications.

 

Advantages

  • Ready for application
  • High Adherence and Resistance
  • Water resistance

 

Range of Application

  • Second hand plaster on blocks or thermal insulating bricks.
  • Smoothing surfaces of fair-face concrete
  • Smoothing and leveling polystyrene panels
  • Application on Sprits surface if there is no humidity and the wall is strong. 

Product Identity   

  • Appearance: Grey cement-based powder   
  • Packaging: 25 kg bags   
  • Storage: 8 months in the original packaging and in a dry place   
  • Particle size: 0 - 2.5mm  

 

Application Data    

  • Mixing Ratio: 25kg in 7-8L water    
  • Pot life: 1 hour at 23ºC  and 50% RH    
  • Thickness: 2-4mm/coat    
  • Consumption: 6-8 kg/m2 depending on surface    
  • Application temperature: +5 ºC - +35 ºC

 

Final Performance    

  • Adhesion strength: 0.6 Ν/mm2– FP:B    
  • Compressive strength: CSIV    
  • Water absorption: W2    T
  • hermal conductivity (λ10,dry): 0.6 W/m∙K

Application procedure   

  • After you place the guides, apply with a rectangular steel trowel in two coats of 10-12 mm each.   
  • Otherwise apply with a trowel in two or more coats of 3-5 mm.   
  • Allow at least 24 hours after the final coat for curing and slightly damped the surface for 2-3 days.  

Substrates Preparation    

  • The substrate must be solid, free of dust, loose parts and oils.   
  • To avoid immediate absorption of mix water by the substrate and for better adhesion saturate the surface to provide a saturated surface dry condition.  

Preparing the mix   

  • Pour the material into clean water and mix (mix in a concrete machine for big quantities or with a low speed electric mixer for small quantities) until a homogeneous lump free mix is obtained.   
  • Allow mixture settle for 5 minutes prior the application. Attention! Additional water will make your mixture sloppy and may cause negative results on final strength.   
  • Use the mixture when is still fresh. Do not leave the mix unmixed for a long time.   
  • Do not mix with water or latex additive when the mixture starts to set in the bucket. In such case the mix should be dropped.

To Find a Shop for this product, click here.