Flashelastic Spa Thick

Description

Super strength thick granulated cement based wall leveling compound, for interior and exterior use.

It conforms to European Standard ΕΝ998-1 specifications.

 

Advantages

  • Ready for application
  • Homogenized Easily, without clotting
  • Excellent workability
  • High Adherence
  • Easy sanding
  • Resistance to shrinkage

 

Range of Application

  • Leveling plastered surfaces, whether painted or not. 
  • Smoothing fair face concrete
  • Smoothing gypsum and cement board surfaces. 

Product Identity    

  • Appearance-color: cement-based white powder    
  • Packaging: 25 kg bags    
  • Particle size: 0-300μm    
  • Storage: 8 months in the original packaging and in a dry place  

Application Data    

  • Mixing Ratio: 25kg in 8-10L water    
  • Pot life: 4 hours/remix every 1 hour at 23ºC  and 50% RH.    
  • Thickness: 1-2mm/coat    
  • Consumption: 2 kg/m2 depending on surface    
  • Application temperature: +5 ºC - +35 ºC  

Final Performance    

  • Adhesion strength: 0.7 Ν/mm2– FP:B    
  • Compressive strength: 3.6  N/mm2 –  CSIII    
  • Water absorption: W1  
  • Apply with spatula in two or more coats if necessary. The first coat fills the roughness of the surface and the second makes the surface smooth.
  • Leave the first coat to set before applying the second one (the waiting time between the two coats should not exceed the 24 hours).   
  • Allow at least 24 hours, after the final coat, for curing. Before decoration, smooth out using fine sandpaper. The surface can then be decorated with a very wide range of paints and coatings like emulsion paint, acrylic-elastomeric paint, texture finishes.  

 Substrates Preparation   

  • The substrate must be solid, free of dust, loose parts and oils.    
  • The substrate has to be flat without any anomalies for better final appliance.   
  • To avoid immediate absorption of mix water by the substrate and for better adhesion saturate the surface to provide a saturated surface dry condition.  

Preparing the mix    

  • Pour the material into a clean bucket containing water and mix with a low speed electric mixer until a homogeneous paste lump free is obtained. Attention! Additional water will make your mixture sloppy and may cause negative results on final strength.   
  • After mixing let the mix to stand for about 5 minutes and mix again for a minute.     
  • Use the mixture when is still fresh. Do not leave the mix unmixed for a long time.   
  • Do not mix with water or latex additive when the mixture starts to set in the bucket. In such case the mix should be dropped.  

To Find a Shop for this product, click here.