Flash Spa Thick

Description

Cement based wall leveling compound for interior use.

It conforms to European Standard ΕΝ998-1 specifications.

Advantages

  • Homogenized easily, without clotting
  • Easy Application
  • High Adherence
  • Easy sanding

Product Identity    

  • Appearance-color: cement-based white powder    
  • Packaging: 10 kg and 25 kg bags    
  • Particle size: 0-300μm    
  • Storage: 8 months in the original packaging and in a dry place  

Application Data    

  • Mixing Ratio: 25kg in 8-10L water    
  • Pot life: 4 hours/remix every 1 hour at 23 oC and 50% RH      
  • Thickness: 1-2mm/coat    
  • Consumption: 2kg/m2 depending on surface      
  • Application temperature: +5 ºC - +35 ºC  

Final Performance    

  • Adhesion strength: 0.3 Ν/mm2– FP:B
  • Bending Strength: 2.4  N/mm2     
  • Compressive strength: 5 N/mm²- CSIII      
  • Water absorption: W0
  • Apply with spatula in two or more coats if necessary. The first coat fills the roughness of the surface and the second makes the surface smooth.
  • Leave the first coat to set before applying the second one (in any case the waiting time should not exceed the 24 hours).   
  • Allow at least 24 hours, after the final coat, for curing. Before decoration, smooth out using fine sandpaper. The surface can then be decorated with a very wide range of paints and coatings like emulsion paint, acrylic-elastomeric paint, texture finishes.

Substrates Preparation    

  • The substrate must be solid, free of dust, loose parts and oils.    
  • The substrate has to be flat without any anomalies for better final appliance.   
  • To avoid immediate absorption of mix water by the substrate and for better adhesion saturate the surface to provide a saturated surface dry condition.  

Preparing the mix   

  • Pour the material into a clean water and mix with a low speed electric mixer until a homogeneous paste lump free is obtained. Attention! Additional water will make your mixture sloppy and may cause negative results on final strength.   
  • After mixing let the mix to stand for about 5 minutes and mix again for a minute.     
  • Use the mixture when is still fresh. Do not leave the mix unmixed for a long time.    
  • Do not mix with water or latex additive when the mixture starts to set in the bucket. In such case the mix should be dropped.  

To Find a Shop for this product, click here.